Mixing 5mg of Semaglutide: A Personal Guide

When I need to mix 5mg of semaglutide, I follow these steps:

1. First, I gather my supplies: the 5mg semaglutide vial, bacteriostatic water or sterile water for injection, alcohol swabs, and a 3mL syringe¹.
2. I allow the semaglutide vial to reach room temperature (about 10 minutes). Then, I clean the tops of both the semaglutide and water vials with alcohol swabs².
3. Using the 3mL syringe, I draw up 5mL of bacteriostatic water or sterile water for injection. This is the common ratio I use for 5mg of semaglutide, but I always follow my healthcare provider's specific instructions.
4. I slowly inject the 5mL of water into the semaglutide vial, aiming the stream against the glass wall to avoid excessive foaming³.
5. I gently swirl the vial to dissolve the powder completely. I'm careful not to shake it vigorously as this may degrade the medication.
6. Once mixed, I refrigerate the solution until I'm ready to use it⁴.

When I'm ready to use the medication:

1. I allow the mixed solution to reach room temperature before use (about 10 minutes).
2. I clean the top of the vial with an alcohol swab before each use.
3. I draw up my prescribed dose using a new sterile syringe.
4. I inject subcutaneously as directed by my healthcare provider⁵.

I always remember to follow the specific instructions provided by my healthcare provider or the medication package, as dosing and mixing instructions may vary. If I have any doubts or questions, I consult with my healthcare provider before proceeding.